- Customer Photos
Motion Pro - Fork Cap Remover Wrench
49mm, 8 point box wrench for removing the fork cap (cartridge) on dual camber closed cartridge forks on late model Yamaha's and Honda's (2010 Honda CRF250R uses 57-8236 Fork cap wrench).
50mm, 6 point box wrench for removing the fork cap (cartridge) on WP 4860 MXMA dual chamber closed cartridge (WP USD 48mm) forks on late model KTM's.
12mm slot for holding the damper rod for removing the rebound bolt. This allows for the removal of the cartridge from the lower fork leg
Made of billet 6061-T6 and anodized Motion Pro blue
Laser engraved markings with Motion Pro logo
Original Motion Pro design
Reviewed by 1 customer
Displaying review 1
Comments about Motion Pro - Fork Cap Wrench:
The wrench works fine when the forks are off the bike. But was impossible to use to loosen the caps when the forks were in the triple clamps. Due to clearance issues with the handlebar mounts. I would give the wrench 5 stars if it were an open end wrench. So I could loosen the caps before I remove the forks. I think I'll modify the wrench I purchased.